Nested System Option - Installing Your Own Nest Thermostats and Cameras

When you are arranging a nest installation, you've got a lot of things to consider. First of all, it's always best to make sure that the new installation is a protected one. Security cameras and other devices can be fun, but they may also be harmful if not installed properly. If you're using wired security cameras, then be sure the cables run through the walls and in the right room. Additionally, it is advisable to use a gas-powered backup in case the power goes out.

Turn off the power to the principal thermostat. Locate the right circuit breaker, then mark it, and then turn it to the"On" position.  Thi công lắp đặt camera  coming from the old thermostat for their corresponding sockets. Each wire going out of your wall should go to a specific marked interface on the new thermostat (V, R, Y, or G, for instance ) Test the connection to be sure that they aren't leaking.

You are learning thermostat e and c-wire interface today, but what should you need to track an unattended baby?  http://cameraipgiasi.com/bao-gia-thi-cong-lap-dat-camera-giam-sat-tai-nha/  is a perfect response for this particular situation. It's a great tool for parents to keep track of their small one while away from home. Perhaps you will consider buying a few more of these doors to your rooms: the nursery along with the bathroom. If you set a motion detector camera in every one of those rooms, you'll have double security for protecting your kids from the perils of a burglar.

Now that your new thermostats and cameras are in place, you need to look after the existing doorbell cut plate. Connect the wires coming from the brand new thermostats and cameras to their corresponding outlet ports. You will also have to attach the trim plate into its base plate using screws and then tie a knot at each of the three holes. Tighten the screws firmly but gently enough in order to not harm the trim plate.

Last but not least, you have to set up your smart thermostat into the c Terminal (the black box that is situated between your cabling at the wall and your doorbell c-terminal.) The approach is actually quite simple. There will be a white wire going from the bottom plate into the c terminal, also there will be a green wire going in the c terminal into this white wire. These wires form the communication channel between your Nest Thermostats and the remainder of your automation system. You should only join the c-terminal to its corresponding outlet port when there is a functioning net connection, otherwise it will stop your Nest Thermostats from communicating with the rest of your automation system.

Once all this is in place, you can test the doorway and the trim plates to make certain that they operate properly. If you discover any issues with these measures, you can continue on to Step 5. This next part may be more difficult than the previous ones, as it requires you to cut through a few walls and run wiring from here to there. I would recommend doing this at a very careful and organized fashion, so don't skip this step if you aren't confident with cutting edge walls. If you've done everything correctly, your fresh nest setup should be complete.